Type on Predefined baseline?

More
1 year 3 months ago #4045 by Flashemb
For the life of me I can not seem to figure out how to use a Predefined Baseline!

I want to define a Circle of a specific size instead of drawing an arc.

Please Log in or Create an account to join the conversation.

More
1 year 2 months ago #4060 by Khieng
Replied by Khieng on topic Type on Predefined baseline?
Have you had a look at our help site, there's a lot of information regarding baselines and adjusting there.

www.wilcom.com/help/e4/es/en/index.htm#t...baselines&rhsyns=%20

Also if that doesn't help , please get in contact with our support team with your dongle serial number and we'll be able to assist you further.

Please Log in or Create an account to join the conversation.

More
1 year 2 months ago #4085 by Flashemb
Thank you for the Response, I did finally mange to understand how to adjust the diameter of the circle baseline.

It just seems counter intuitive to me. I want to draw the circle then out in in the design where it goes and then place type on it. but you actually have to just give it Radius and then place it after you enter the Text.

This is all for a Circle baseline which is fine. It is what I was trying to do. I'm still not sure I under stand what a predetermined Baseline is. I would have thought you would draw a line or arc or circle and select it as the predetermined Baseline. but that is not how it seems to work!

Thanks for the Links Reading that helped some!

Please Log in or Create an account to join the conversation.

Time to create page: 0.115 seconds
Powered by Kunena Forum